DIMENSION 4600C VIDEO DRIVER

Reinstall all USB devices, check cable connections, and then restart the computer. If you receive this message after you make changes in the system setup program, enter the system setup program and restore the original value s. If the problem persists, see “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical assistance. The operating system cannot be located on drive A or drive C. Ensure that the drive is installed correctly in the computer and defined correctly in the system setup program.

Uploader: Kagarisar
Date Added: 15 December 2012
File Size: 29.19 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 58019
Price: Free* [*Free Regsitration Required]

Slave DMA register failure. An error occurred with the keyboard connector. If the computer malfunctions, the color and sequence of the lights identify the problem. Verify that the memory modules that you viedo installing are compatible with your computer. Master DMA register failure. The BIOS cannot communicate with the floppy drive or hard drive controller.

Check the interface cable at both ends. Determine if a conflict exists by removing a card and then restarting the computer. Ensure that the cables are properly connected from the hard drive, CD drive, and DVD drive to the system board.

  MINOLTA COLOR PAGEWORKS EX DRIVER DOWNLOAD

If the problem persists or the computer has integrated video, see “Contacting Dell” in your Owner’s Manual. If the computer has a video card, remove the card and reinstall itand restart the computer.

If you have two or more memory modules installed, remove the modules, reinstall one moduleand then restart the computer. Strike F1 to retry reboot, F2 for setup utility. Master interrupt mask register failure.

Advanced Troubleshooting

Enter the system setup programverify the system configuration, and then restart the computer. The system configuration information in the system setup program is incorrect or the battery charge may be low. Memory modules are detected, but a memory configuration or compatibility error exists. Enter the system setup program and confirm that drive A or drive C is properly identified.

Continue until you have identified a faulty module or reinstalled all modules without error. Memory not being properly identified dimensino used.

Your computer might emit a series of beeps during start-up if 4600f monitor cannot display errors or problems. Interrupt vector loading failure. If you receive this message after you make changes in the system setup program, enter the system setup program and restore the original value s.

  HL L8350CDW DRIVER DOWNLOAD

Serial or parallel port test failure.

dumension A possible expansion card failure has occurred. Diemnsion “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical assistance. Error in the DMA controller on the system board. If the computer starts normally, move the memory module to a different connector and restart the computer. If the problem persists, reinstall the card that you removed, remove a different card, and then restart the computer.

If available, install properly working memory of the same type into your computer.

Dell Dimension C Specs – CNET

Timer-chip counter 2 failure. The computer is in a normal off condition or a possible pre-BIOS failure has occurred.

A possible floppy or hard drive failure has occurred.

Keyboard Controller Test failure. Reseating the memory modules may fix the beep code errors in the following table. Memory failure above address 0FFFFh.

An error in the address decoding circuitry in the memory has occurred.